Hand Press Machine for Grommets, Eyelets, Rivets, Studs

Hand press has a wide range of applications. You can use it to rivet buttons, saddlery rivets and other components intended for riveting.
It has a low weight.
Suitable dies molds with M8 thread must be purchased for the hand press.
The hand press must be screwed to a solid base, screws are not included.
Dimensions see photo.
The dimensions of the lower part (base) are 9 x 17.5 cm.
The height from the end of the handle to the table is 38 cm. The narrowest point of the base is 5 cm. The length of the base is 17.5 cm. The width of the top of the hand press, measured where the handle is attached, is 3.5 cm.

The pressure lever has an adjustable screw on the bottom, which can be used to extend the dies mold and adjust it to the length of the dies mold.